![]() ![]() Loaded: loaded (/lib/systemd/system/rvice enabled vendor preset: enabled)Īctive: active (running) since Sat 03:05:25 EDT 1min 31s agoĭocs: PiAware - ADS-B and MLAT Receiver - FlightAware ![]() Sudo piaware-config receiver-host 127.0.0.1 **Note: in above configuration, replace 192.168.0.22 by the local IP of FR24 Receiver**Ĭonfigure Piaware as follows to use data from ModeSMixer2 sudo piaware-config receiver-type other Further, the port 30005 is in use by dump1090-fa, so modesmixer2 should use another port say 31005 Configure ModeSMixer2 as follows: -inConnectId 192.168.0.22:30003:FR24 Please note that the dump1090-fa is also running, which will receive MLAT feedback results on port 30104 and show it on Skyaware map. You can therefore install ModeSMixer2 on the Raspberry Pi and configure it as given below. The Beast is a little long in the tooth, so Dump1090/Pi4 may be comparable.FA Stats page shows that you are using Piaware SD card image 5.0. My biggest question is whether it would be advantageous for me to stick with the Beast or give Dump1090 a try. Not exactly a Linux wizard, however, so I am not sure if this can be done cleanly. I am thinking that with the Pi, I can ideally run PP, ACARSDec, DumpVDL2 as well as HFDL and maybe airband audio on one or two devices. With the release of the RPi 4, I am thinking about changing my setup. I sit down in front of my PC and find that PP has closed at some point. I am currently experiencing a possible networking issues where planeplotter shuts down randomly. I also use a Raspberry Pi 3B+ to run ACARSDec and DumpVDL2 off and on along with VirtualRadarServer to feed to ADSBExchange, Live-military-mode-s and. I currently run PlanePlotter with a Mode-S Beast. I am contemplating a project and am looking for thoughts, opinions and such. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |